1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Rear bumper protection

Discussion in 'Prius v Accessories and Modifications' started by alanvw, Nov 22, 2011.

Page 1 of 3
  1. alanvw

    alanvw New Member

    Joined:
    Nov 22, 2011
    7
    1
    0
    Location:
    East Coast
    Vehicle:
    2012 Prius v wagon
    Model:
    Five
    Hello. New v Five w/ AT package owner here.
    Question: we will be carrying dogs every now then. They will jump into the wagon from the back. I’m concerned about that area getting scratched up...is there a protective skin or other material available?
     
    #1 alanvw, Nov 22, 2011
    1 person likes this.
  2. Flyman

    Flyman Junior Member

    Joined:
    Nov 2, 2011
    64
    12
    0
    Location:
    Packwood, Washington
    Vehicle:
    2012 Prius v wagon
    Model:
    Two
    You can purchase one through this site, I did. Enjoy your new v, we sure do.
     
    #2 Flyman, Nov 22, 2011
  3. alanvw

    alanvw New Member

    Joined:
    Nov 22, 2011
    7
    1
    0
    Location:
    East Coast
    Vehicle:
    2012 Prius v wagon
    Model:
    Five
    I saw that link but its for the 2011 model and not the wagon (v) - will that still fit the wagon?

    thanks,
     
    #3 alanvw, Nov 22, 2011
  4. mpruis

    mpruis Junior Member

    Joined:
    Apr 12, 2004
    27
    0
    0
    Location:
    Michigan
    Vehicle:
    2005 Prius
    Model:
    N/A
    Hello alanvw,
    You can purchase the appropriate Prius v applique through Toyota and I think
    through Priuschat.
    I wanted the thicker (usually black) plastic bumper protector that fits over the
    edge of the bumper for my Prius v three, and a Toyota salesperson remarked
    that the rear of the wagon looked similar to a Matrix. So I looked at a few Matrix, and ordered a rear bumper protector from Toyota (I think it was a
    Clearwater, Florida dealer) online, for a 2003-2008 Matrix. I looked like the
    2003-2008 Matrix black bumper cover would be a better fit than the bumper
    protector sold for the 2009+ Matrix, because the bumper curves up to the sides
    quicker. And it fits the edge perfectly, but it doesn't go all the way to the front of the bumper, leaving about an inch of bumper uncovered. Anyway, I'm happy with my initial solution. This bumper protector is about 40 inches wide,
    and three inches deep.
    But, after watching a video from Canada Bob; he has a bumper protector,
    apparently sold, so far, only in Canada, which looks like it covers more of the
    bumper (deeper). I've been searching Toyota parts suppliers in Canada, but
    haven't found a supplier yet. Depending on price, when I find the canadian
    supplied Toyota product, I will replace my Matrix (looks like it was made for
    Prius v) bumper protector. I only paid $34 for the Matrix OEM protector.

    ps: I've attached images (if that works), but personally, I would wait to see
    the OEM Toyota product.
     

    Attached Files:

    #4 mpruis, Nov 22, 2011
  5. Paradox

    Paradox Prius Enthusiast / Moderator
    Staff Member

    Joined:
    Sep 22, 2005
    29,110
    8,589
    201
    Location:
    USA
    Vehicle:
    2014 Prius v wagon
    Model:
    Five
    Yes, here's a picture:

    [​IMG]

     
    #5 Paradox, Nov 22, 2011
  6. M8s

    M8s Retired and Lovin' It

    Joined:
    Sep 11, 2008
    614
    113
    33
    Location:
    Colorado and Arizona
    Vehicle:
    Other Hybrid
    Model:
    Limited
    Yeah Paradox, that bumper protector "applique" really won't do the job for us.

    We put bags of golf clubs into, or pull them out of, the back of our vee all the time and eventually they will drag on the bumper. Also, I like to put my foot on the bumper to tie my golf spikes. The heavy black bumper protector is needed for those kinds of uses. I have them on the 2009s and the bumpers still look like new.
     
    #6 M8s, Nov 22, 2011
  7. Paradox

    Paradox Prius Enthusiast / Moderator
    Staff Member

    Joined:
    Sep 22, 2005
    29,110
    8,589
    201
    Location:
    USA
    Vehicle:
    2014 Prius v wagon
    Model:
    Five
    Ahhh, ok, I hear ya' and understand. I'm sure they'll be offered in time, but I have not seen them for the v in particular as of yet.
     
    #7 Paradox, Nov 22, 2011
  8. Danny

    Danny Admin/Founder
    Staff Member

    Joined:
    Nov 24, 2003
    7,093
    2,100
    1,174
    Location:
    Charlotte, NC
    Vehicle:
    2013 Prius Plug-in
    Model:
    Plug-in Base
    We'll have the bumper protector in stock soon. I was visiting Southeast Toyota last week and they are mass producing one that should be available very soon.
     
    #8 Danny, Nov 23, 2011
  9. Theophaneia

    Theophaneia New Member

    Joined:
    Nov 30, 2011
    2
    0
    0
    Location:
    Eugene, OR
    Vehicle:
    2012 Prius v wagon
    Model:
    Three
    Do you have a picture of your wagon with the Matrix bumper guard?
    Thanks!



     
    #9 Theophaneia, Nov 30, 2011
  10. mpruis

    mpruis Junior Member

    Joined:
    Apr 12, 2004
    27
    0
    0
    Location:
    Michigan
    Vehicle:
    2005 Prius
    Model:
    N/A
    Hello Theophaneia,
    I updated my original post with a pic (top view), the other pic shows both pri,
    (no extra cost)
     
    #10 mpruis, Nov 30, 2011
  11. Theophaneia

    Theophaneia New Member

    Joined:
    Nov 30, 2011
    2
    0
    0
    Location:
    Eugene, OR
    Vehicle:
    2012 Prius v wagon
    Model:
    Three
    Thanks for that! The picture is very helpful. I think we may have to go that way as we move a whole lot of cargo, and it was invaluable on my previous vehicle...which amusingly was an 08 Matrix.

     
    #11 Theophaneia, Nov 30, 2011
  12. alanvw

    alanvw New Member

    Joined:
    Nov 22, 2011
    7
    1
    0
    Location:
    East Coast
    Vehicle:
    2012 Prius v wagon
    Model:
    Five
    Anyone know if the 2010-2011 rear rubber bumper protector will fit the 2012 v "wagon"?

    Item: 00016-47040

    thanks
     
    #12 alanvw, Dec 1, 2011
  13. txl146

    txl146 Member

    Joined:
    Jul 4, 2011
    301
    19
    0
    Location:
    NY
    Vehicle:
    2011 Prius
    Model:
    Two
    I bought black plastic piece for around $40 from eBay. I also applied clear film on the rear bumper, which came out great ($12 from amazon).
     
    #13 txl146, Dec 9, 2011
  14. thor777

    thor777 New Member

    Joined:
    Nov 29, 2011
    2
    0
    0
    Location:
    SoCal
    Vehicle:
    2012 Prius v wagon
    Model:
    Three
    do anyone have instructions on how to apply the factory rear bumper applique for the Prius V? I bought one from the shop here but it says I have to go the dealer for instructions?
     
    #14 thor777, Dec 9, 2011
  15. txl146

    txl146 Member

    Joined:
    Jul 4, 2011
    301
    19
    0
    Location:
    NY
    Vehicle:
    2011 Prius
    Model:
    Two
    Looks like it will need to be installed using soapy water and alcohol...
     
    #15 txl146, Dec 9, 2011
  16. bgvalley

    bgvalley New Member

    Joined:
    Sep 19, 2010
    2
    0
    0
    Location:
    NE Arkansas
    Vehicle:
    2010 Prius
    Model:
    II
    I bought a 2011 Prius and was dismayed to see there was no protection on the back bumper deck. The Toyota dealer here told me the black bumper protector was no longer available. I went to eBay and there were some there from a Toyota dealer in Alabama? if I remember correctly for $24. Took a chance and ordered one, works just fine. Had to have my oil changed so I took it to dealer and asked them to put it on. Perfect!!!!!!
     
    #16 bgvalley, Dec 10, 2011
  17. RRxing

    RRxing Senior Member

    Joined:
    Jul 7, 2009
    2,518
    1,790
    0
    Location:
    NEPA
    Vehicle:
    Other Hybrid
    Model:
    Limited
    This is for the 2010 Gen III but should be similar...

    View attachment 33678
     
    #17 RRxing, Dec 10, 2011
    2 people like this.
  18. thor777

    thor777 New Member

    Joined:
    Nov 29, 2011
    2
    0
    0
    Location:
    SoCal
    Vehicle:
    2012 Prius v wagon
    Model:
    Three
    Great!! Thanks so much!!! :D
     
    #18 thor777, Dec 11, 2011
  19. M8s

    M8s Retired and Lovin' It

    Joined:
    Sep 11, 2008
    614
    113
    33
    Location:
    Colorado and Arizona
    Vehicle:
    Other Hybrid
    Model:
    Limited
    #19 M8s, Dec 12, 2011
  20. webenchantressde

    webenchantressde Junior Member

    Joined:
    Mar 21, 2007
    12
    0
    0
    Vehicle:
    2012 Prius v wagon
    Model:
    Five
    my deployed hubby just surprised me, and ordered a 2012 Prius V package 5 for me! This replaces my 2006 Prius that was totaled by hail over the summer... I am super exited! If you guys get word on a plastic, black, thick bumper cover for the V, please let me know. Definitely a must have. I don' t think it will be in until February/March was the estimate. Thanks!
     
    #20 webenchantressde, Dec 23, 2011
(You must log in or sign up to post here.)
Page 1 of 3