1. Attachments are working again! Check out this thread for more details and to report any other bugs.

User programming a smart key success reported

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by glenk, Aug 8, 2006.

  1. glenk

    glenk Member

    Joined:
    Dec 13, 2005
    109
    0
    0
    Location:
    Fairfield, CA
    Vehicle:
    2013 Prius
    Model:
    Three
    I saw this in the toyota-prius@yahoo group.

    The process seems to obtuse to be a gag but I just don't know:




    Success! Programming a new smart key
    Posted by: "rzeff" [email protected] rzeff
    Tue Aug 8, 2006 7:39 am (PST)
    I purchased a smart key for my 2005 Prius on Ebay. Cost was $129.00
    + ~$5.00 shipping.
    The dealer wanted $250.00 + $50.00 programming + Tax.

    I received the key today and followed the wacky instructions below.
    It worked!!

    *********************************************************

    TOYOTA PRIUS 2004-2007 SILVER EMBLEM ON BACK ONLY!!

    **Remote transmitter added or replaced.

    (1) Driver's door open, key removed from ignition switch.
    (2) Within 5 seconds:
    a) Insert and remove the key from the ignition switch twice.
    (3) Within 40 seconds:
    a) Close and open driver's door twice.
    (4) Insert and remove the key from the ignition switch twice.
    a) Close and open driver's door twice.
    (5) Insert the key into the ignition switch and close the driver's
    door.
    (6) Within 40 seconds:
    a) Switch ignition ON and OFF once to program a remote transmitter
    code whilst retaining the original codes or twice to program a
    remote transmitter code whiles erasing the original codes. Three
    times to check how many remote transmitters are currently registered
    or five times to erase all registered codes.
    (7) Remove key from ignition switch.
    (8) Within 5 seconds:
    a) System should now lock and unlock vehicle. Once, twice, or five
    times depending which mode has been selected. One to four times
    slowly to indicate number of remote transmitters registered.
    (9) Within 40 seconds:
    a) Press and hold LOCK and UNLOCK remote transmitter buttons,
    together, for 1.5 seconds.
    (10) Within 3 seconds:
    a) Press LOCK remote transmitter button.
    (11) System should now lock and unlock vehicle. Once to confirm
    registration, twice to indicate registration has failed.
    (12) Within 40 seconds:
    a) Repeat button procedure to program remaining remote transmitters.
    NOTE: To exit programming mode: Open driver's door.
    NOTE: A maximum of 4 remote transmitters can be programmed.
     
  2. cagemo

    cagemo Member

    Joined:
    Jun 25, 2006
    132
    6
    0
    Location:
    california
    Vehicle:
    2014 Prius
    Model:
    II
    Extremely doubtful these worked to program a Smart enabled remote (the ones with a silver logo). These instructions have made the rounds before, and I've personally tried them at least 30 times and ten different ways to program a new Smart key. Never worked, and not so much as a peep from the car to indicate it was in a learning or programming mode.
     
  3. Begreen

    Begreen Member

    Joined:
    Jan 15, 2006
    670
    10
    0
    Location:
    Western WA state
    Vehicle:
    Other Electric Vehicle
    Model:
    N/A
    Hmmm. Stand on your left foot only. Place your right hand against the driver's side window...... Feel the pane.