Separate names with a comma.
Been off-line for quite sometime so I've only now seen your post. The repair was done on my wife's '09. The ballast was purchased used from an...
In the case of the smart key button, OUT = ON
POA80 = HV Battery Cell Delta State of Charge Fault.
In other words, one or more of the individual cells which make up the pack is outside the...
Ha so now I find the post on the HID warranty extension. Lucky me with 56K on an '09 and a ballast and headlight assembly seal issue but not a...
This is a long post, for instructions on DIY HID ballast removal w/o cutting wires or plastic (it is possible), skip to the end.
I over the past...
HID lamp connector
And we are out!
Once in the corner there is clearance enough for removal
Slide the connector sideways to the corner
Now past the leveling connector, we are looking through the ballast opening
Work it past the protrusion from leveling connector below. It is a tight fit but should not require excessive force
The flat metal surface of the connector must be held tight to the flat surface of the plastic enclosure
Flip the cover over, remove the black wiring connector (already removed in photo) and the 3 screws